Corbeau 3-Point, 2" Double Release Harness Belts are unique in that there is an extra disconnect buckle behind the harness slots where the two straps form a Y. In other words, a typical 3-Point harness belt has the two straps that go over the shoulders and through the harness slots. Those two straps then come together to form a single strap that mounts in the rear area of the vehicle. Depending on where you mount this rear strap, it can sometimes make it difficult for passengers to get in and out of the back seat. With the 3-Point Double Release harness Belt, you can disconnect the rear strap with the push of a button and then reengage the strap once your passengers are settled. As with all Corbeau harness belts the lap belts bolt to your factory bolt hole locations. The plus to this is these factory bolt holes have been tested by the manufacture and are the safest way to install your harness belts. The Double Release Harness Belt is recommended if you have passengers who frequently get in and out of the back seat or if you frequently use the back seat for storage. For added comfort, each harness belt is made with a pressure reducing waist pad. The 3-Point Double Release Harness Belts come in either bolt-in or snap-in mounting. With bolt-in mounting, the ends of the straps bolt into your mounting location. With snap-in mounting, eye bolts are included that bolt into your mounting locations. The ends of your harness straps then snap to those eye bolts. Two inch harness pads are also recommended to prevent the shoulder straps from rubbing your neck.
*This belt was intended for off highway use. In many cases our belts meet and exceed the FMVSS standards but they are not technically FMVSS approved. You purchase and use them at your own risk.